⭕ RANGE ROVER 4.9 LITRE RPI V8 ENGINE

RPI estimate power output @ 320bhp

This engine has been run and is in superb condition. It will be supplied complete with the engine wiring harness, a matched, tuned & re-chipped GEMS engine management ECU from RPI, full coil pack complete with 8mm leads, and the exshaust Y pipe down pipes with high flow 100 cell Cats for enhanced exhaust flow performance, plus two Lambda (oxygen) sensors to complete the system.

The engine is effectively a Plug & Play item for the Range Rover P38 models from 1994-1998, which use the Gems system. From 1999 the Bosch system was used which did not have the rectangular plenum chamber on the top of the engine. This power plant is also ideal for kit cars requiring 320bhp, as it comes complete with engine loom, ECU and all parts needed except the exhaust manifolds, which are standard P38 V8 branch headers.

The Engine specifications are as follows:

86-36 CRANKSHAFT

CROSS BOLTED BLOCK

3.5 STD MAINS & ENDS

94mm BORE

94mm FORGED POCKETED PISTONS

INCREASED COMPRESSION RATIO: 9.9-1

FULLY BALANCED ENGINE

STAGE 3 HEADS PORTED & GAS FLOWED

TUNED, SHORTENED & ENLARGED AIR INTAKE STACKS

PORTED & FLOWED INTAKE MANIFOLD

ALIGNED & MATCHED INLET PORTING

KENT 8200 CAMSHAFT WITH LIFTERS &RODS

LOW BACKPRESSURE 100 CELL CATS ON Y PIPE EXHAUST

COMES COMPLETE WITH LAMBDAS ON DOWNPIPES

GEMS RE-CHIPPED TUNED RPI ENGINE CONTROL ECU